White Melt and Pour
Loaf or Tray Mold
Fragrance (optional)
Soap Scraps (Ours are from the Soapy Plaid Project)
Microwave Safe Bowl (Pyrex)
Rubbing Alcohol in a Spritzer Bottle
Step 1: Melt just enough white melt and pour soap to fill your mold about half way full.
Hint: If your soap scraps are fresh and strongly scented you may not need to add any additional fragrance to your melted soap. However, if your scraps are a little older or lightly scented then you can add more fragrance now.
Step 2: Make sure your soap is no hotter than 120 degrees (if the soap is any hotter it will melt your embedding pieces). Pour the soap into your loaf or tray mold and spritz with rubbing alcohol to eliminate any bubbles.
Step 3: Grab your soap scraps and generously spritz them with alcohol (they should look wet all over). Once they have had a good dousing, sprinkle them into the melted white soap. Spritz the top of the soap again with rubbing alcohol.
Hint: You can flatten the embeds down into the soap so they are fully submerged or leave some poking out the top for a different look.
Optional: If needed, you can melt and pour some additional white soap and fill your mold the rest of the way up. If your mold is completely full after adding your scraps then you are done. Let cool completely.
Step 5: Once the soap is cooled and hardened you can release the soap from the mold and cut into bars. Cutting the soap will reveal all the hidden chunks inside!
Hint: Again, you can trim all the sides of your soap for a nice clean look, or leave the top of the soap with a few embeds sticking out for a more fun, textured bar.
Have a question about this blog post? Come join us at Bramble Berry’s Facebook page and we can help you out with any of your soapy questions!